valutazioni - 2, GPA: 3.5 ( )

Istruzioni per l'uso Hotpoint-Ariston, Modello F 83.1 IX /HA

Produttore : Hotpoint-Ariston
File Size : 3.97 mb
File Nome :
Lingua di insegnamento: ruitenesfrpt
Vai a scaricare

Facilità d'uso

It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x 560 mm (see diagrams). Centring and fastening Position the 4 tabs on the side of the oven according to the 4 holes of the outer frame. Adjust the tabs according to the thickness of the cabinet side panel, as shown below: thickness of 20 mm: take off the removable part of the tab (see diagram) □ □ thickness of 18 mm: use the first groove, which has already been set in the factory (see diagram) thickness of 16 mm: use the second groove (see diagram) Secure the appliance to the cabinet by opening the oven door and putting 4 screws into the 4 holes of the outer frame. ! All parts which ensure the safe operation of the appliance must not be removable without the aid of a tool. 14 Centring and fixing* 1. Position brackets "A" against oven support "B". 2. Position tabs "C" against brackets "A". If the thickness of the cabinet side panel: • is 16 mm thick: place the tab so that the number 16 written on it is facing you; • is 18 mm thick: place the tab so that the part without any text is facing you; • is 20 mm thick: do not fit the tab. 3. Fix the brackets and tabs onto the edge of the cabinet side panel using screws "D". 4. Fix the oven to the cabinet using the screws and plastic washers "E". Electrical connections ! Ovens equipped with a three-pole power supply cable are designed to operate with alternating current at the voltage and frequency indicated on the data plate located on the appliance (see below). Fitting the power supply cable 1. Open the terminal board by inserting a screwdriver into the side tabs of the cover. Use the screwdriver as a lever by pushing it down to open the cover (see diagram). 2. Loosen the cable clamp screw and remove it, using a screwdriver as a lever (see figure). 3. Remove the wire contact screws L-N- , then fasten the wires under the screw heads, respecting the colour code: Blue (N), Brown (L) and Yellow-Green Verde (i). Connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate (see side). The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains, suitable for the load indicated and complying with current electrical regulations (the earthing wire must not be interrupted by the circuit-breaker). The supply cable must not come into contact with surfaces with temperatures higher than 50°C. ! The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations. Before connecting to the power supply, make sure that: • The appliance is earthed and the plug is compliant with the law. • The socket can withstand the maximum power of the appliance, which is indicated on the data plate (see below). • The voltage must be in ...

Questo manuale è adatto anche per i modelli :
Forni - F 83.1 /HA (3.97 mb)
Forni - F 937 C.1 /HA (3.97 mb)
Forni - F 937 C.1 IX /HA (3.97 mb)
Forni - FC 83.1 /HA (3.97 mb)

Scrivi la tua opinione del dispositivo

Il messaggio
Il tuo nome :
Inserire le due cifre :